Why do we need to pay attention to the PCB Dispensing Machine Maintenance ？

The daily work of the dispenser maintenance has a great influence on the service life of the dispenser and the smoothness of the normal use process. The following are the daily maintenance steps of the PCB Dispenser:

1. Replace the rubber type and clean the pipeline. At this point, first close the feed valve, open the discharge valve, and discharge the remaining rubber from the rubber barrel, close the discharge valve, open the feed valve, pour the cleaning solvent into the glue storage tank, activate the body, and press the solvent according to the normal operation mode. Rinse out.
2. If the air intake is not normal and water vapor is found, please check the water in the pressure regulating filter or check whether the air pressure source is different. Before using the glue in large quantities, please use a small amount of trials to master the use of the product to avoid mistakes. When the test is no problem, use a double-drop glue machine or a two-liquid glue machine for mass production; The vacuum system vacuums and defoams the glue to eliminate air bubbles generated during the stirring process, or is allowed to stand for 10-20 minutes before use, so that the bubbles generated during mixing are eliminated in time, and the amount of glue mixed together is more.
3. Please clean the machine part regularly to increase the service life. The more the amount of glue mixed together, the faster the reaction will be, and the faster the curing speed will be. Therefore, it is necessary to properly mix the glue according to the actual production situation, otherwise the glue will be wasted. Eliminate accidents and increase production efficiency. Today's liquid control technology and dispensing equipment are widely used in various production areas in modern industry.
4. When the machine is deactivated for a long time, the power should be unplugged, which will not only prolong the life of the machine but also save a lot of electricity. With the ever-changing industrial development needs, liquid control technology and dispensing equipment are also constantly evolving to ultra-high precision control and diversification and specialization.

Note: After each use, clean it well. Wipe it all the time. Rub it with alcohol. It is best to apply oil or butter to the parts that are often moving. Keep it lubricated. If it is not necessary to burn the glue for a long time. Otherwise, it will be solidified in the LED dispenser, and it will be cleaned up, which is very troublesome.